firmware upgrade :

0- SWITCH OFF 24V on FEB
1- Switch SW2 (close to USB connector) : put switch #2 to OFF position (this will disconnect the FX3 USB uC EEPROM thus avoid it to load the AUG unige FW and to boot on its default bootloader mode)
2- SWITCH ON 24V on FEB
3- Launch FEB host application (an error could be detetected since we are in bootloader mode now : click OK)
4- Verify 'Bootloader' in USB device list
5- Menu Util\Fx3\upgrade
6- Switch SW2 (close to USB connector) : put switch #2 to ON position (like the message box ask)
7- 	FEB v1 : choose 'AUG-x.x-500KHz.img' file host app/util directory (x.x = FX3 fw version)
	FEB v2 : choose 'AUG-x.x-1MHz.img' file host app/util directory (x.x = FX3 fw version)
8- wait prog. end (~1 min.)
9- SWITCH OFF & ON 24V on FEB

-----------------------------------------------------------------
Driver installation :
The 1st time you install the FX3 FW for Unige VID/PID, you'll need to tell to windows the driver path :
	- copy locally and unzip 'UnigeDriver.zip'
 	- connect the USB device
	WIN7:
  		- If 'WestBridge' or 'AUG' is not shown in the device manager, uninstall the driver for the FX3 BootLoader Device and Reconnect the device on USB 
		- Update 'WestBridge' driver by selecting the win7 directory on the path where you unzip the 'UnigeDriver.zip'
		- Accept the warning from windows and install driver

	WIN10:
		- If 'WestBridge' or 'AUG' is not shown in the device manager, uninstall the driver for the FX3 BootLoader Device and Reconnect the device on USB 
		- In win10/x64 : Double click on the test_certificate.cer file and click on Install Certificates
		- Click Next
		- Choose Place all certificates in the following store and click Browse
		- Choose Trusted Root Certification Authorities and click OK
		- Click Next and Finish
		- Then again re-click on Install Certificates
		- Click Next
		- Choose Place all certificates in the following store and click Browse
		- Choose Trusted Publishers and click OK
		- Click Next and Finish